Unable to connect to Digitizer
Posted: Wed Jan 26, 2011 3:04 pm
Hi!
I know that this topic has been broached before, thus I am loath to do so again, but I haven't come across a solution online for my problem.
I come across the following error message when trying to configure my Digitizer with the iCube Editor:
'Unable to connect to Digitizer'
I have the Digitizer powered on, I have a MIDI-USB interface (Edirol UM-1ex), and I have a test sensor plugged in.
So far as I can establish, my MIDI chain is correct. The interface works great with other equipment of mine, and has the latest drivers. The LED on the UM-1 MIDI interface even goes green when I move the sensor, indicated the Digitizer is spitting out MIDI, which is good.
I can select the UM-1, open it, click edit, just as the 'get started' documentation says, but I just cannot connect to it. It comes up with the error every time.
I've tried different MIDI interfaces, switching the cables, switching which cable was plugged in where. I feel like I've tried everything, yet I'm at a loss.
Does anybody have an suggestions? What might I be doing wrong? What could I try next? I can report back on the progress of anything you'd have me try in order to rectify this problem.
Many thanks to all in advance!
I know that this topic has been broached before, thus I am loath to do so again, but I haven't come across a solution online for my problem.
I come across the following error message when trying to configure my Digitizer with the iCube Editor:
'Unable to connect to Digitizer'
I have the Digitizer powered on, I have a MIDI-USB interface (Edirol UM-1ex), and I have a test sensor plugged in.
So far as I can establish, my MIDI chain is correct. The interface works great with other equipment of mine, and has the latest drivers. The LED on the UM-1 MIDI interface even goes green when I move the sensor, indicated the Digitizer is spitting out MIDI, which is good.
I can select the UM-1, open it, click edit, just as the 'get started' documentation says, but I just cannot connect to it. It comes up with the error every time.
I've tried different MIDI interfaces, switching the cables, switching which cable was plugged in where. I feel like I've tried everything, yet I'm at a loss.
Does anybody have an suggestions? What might I be doing wrong? What could I try next? I can report back on the progress of anything you'd have me try in order to rectify this problem.
Many thanks to all in advance!